2014-2019 Hiace · Service Manual BODY

Door Control Relay Power source Circuit

Circuit diagnosis · Vehicles built from Dec 2015

Versions by build date: Oct 2014 – Nov 2015 from Dec 2015

DESCRIPTION

This circuit provides power to the door control relay LH*1 or door control relay RH*2.
  1. *1: for LH Side
  2. *2: for RH Side

WIRING DIAGRAM


for LH Side
B369090E03

for RH Side
B369090E02

INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.


1. CHECK DOOR CONTROL RELAY (POWER SOURCE)
  1. Check the malfunctioning relay.

    Result 
    Result
    Proceed to
    Malfunction in LH side
    A
    Malfunction in RH side
    B



B
Go to step 3
A


2. CHECK HARNESS AND CONNECTOR (DOOR CONTROL RELAY LH - BATTERY AND BODY GROUND)

  1. B106251E14
    Disconnect the door control relay LH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    y2-3 (E) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    y2-1 (B) - Body ground
    Always
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Door Control Relay LH)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)

3. CHECK HARNESS AND CONNECTOR (DOOR CONTROL RELAY RH - BATTERY AND BODY GROUND)

  1. B106251E13
    Disconnect the door control relay RH connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    M2-3 (GND) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    M2-1 (ECUB) - Body ground
    Always
    11 to 14 V

Text in Illustration 
*a
Front view of wire harness connector
(to Door Control Relay RH)


NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)


← Door Control Relay Power source Circuit (Oct 2014 – Nov 2015)PRECAUTION (from Oct 2014) →