REMOVAL
Removal / installation · Vehicles built Oct 2014 – Dec 2014
| 1. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY |
Disconnect the connector.

Using a screwdriver, bend the tabs of the lock washer.

- NOTICE:
- Be careful not to damage the park/neutral position switch assembly.
- HINT:
- Tape the screwdriver tip before use.
Remove the nut and lock washer.
Remove the bolt and park/neutral position switch assembly.
- HINT:
- Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch assembly as the detent spring may become detached from the manual valve lever shaft.
