2014-2019 Hiace · Service Manual TRANSMISSION

REMOVAL

Removal / installation · Vehicles built from Jan 2015


1. REMOVE SHIFT LEVER CAP

  1. C318921E01
    Using a screwdriver, detach the 2 claws and remove the shift lever cap from the floor shift position indicator housing sub-assembly.
    Text in IllustrationĀ 
    *a
    Protective Tape

    NOTICE:
    Be careful not to damage the shift lever cap and floor shift position indicator housing sub-assembly.

    HINT:
    Tape the screwdriver tip before use.


2. REMOVE SHIFT LEVER KNOB

  1. C318922
    Twist the shift lever knob in the direction indicated by the arrow and remove it.


3. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY

  1. C318923
    Detach the 8 claws and remove the floor shift position indicator housing sub-assembly.


4. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO. 1

  1. B365546
    Using a clip remover, remove the 2 clips

  1. Detach the 3 claws and remove the instrument panel under cover sub-assembly No. 1.


5. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER

  1. B365544
    Using a clip remover, remove the 2 clips.

  1. Detach the 4 clips and remove the instrument panel finish lower.

  1. Disconnect each connector.

  1. B102838
    Push the positions indicated by the arrows in the illustration to disconnect the fuel lid lock control cable and bonnet (hood) control cable assembly from the instrument panel finish lower.


6. REMOVE PARKING BRAKE HOLE COVER

  1. B365547
    Detach the 6 claws and remove the parking brake hole cover.

  1. Disconnect each connector.


7. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER

  1. B365551E01
    Detach the 8 claws and remove the instrument panel finish panel lower center.
    Text in IllustrationĀ 
    *A
    for Manual Transmission
    *B
    for Automatic Transmission


8. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
  1. Move the shift lever to N.

  1. C299522
    Disconnect the end of the transmission control cable assembly from the shift lock control unit assembly.

  1. C299523
    Using a screwdriver, pull out the stopper of the transmission control cable assembly.

    HINT:
    Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

  1. C299524
    Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lock control unit assembly.

    NOTICE:
    Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.


9. REMOVE SHIFT LOCK CONTROL UNIT ASSEMBLY

  1. C299525
    Disconnect the 2 connectors and clamp from the shift lock control unit assembly.

  1. Remove the 4 bolts and shift lock control unit assembly.

← ON-VEHICLE INSPECTION (from Jan 2015)DISASSEMBLY (from Jan 2015) →