2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


CHECK FUEL PRESSURE
  1. READ DATA LIST

    1. Warm up the engine.

    2. Turn the ignition switch off.

    3. Connect the GTS to the DLC3.

    4. Turn the ignition switch on.

    5. Turn the GTS on.

    6. Enter the following menus: Powertrain / Engine and ECT / Data List.

    7. Read the Data List.

      Tester Display
      Measurement Item/Range (Display)
      Normal Conditions
      Common Rail Pressure
      Fuel pressure/ Min.: 0 MPa, Max.: 655.350 MPa
      25 to 35 MPa: Idling
      Target Common Rail Pressure
      Target common rail pressure/ Min.: 0 kPa, Max.: 655350 kPa
      20 to 160 MPa


CHECK FOR FUEL LEAKS
  1. PERFORM ACTIVE TEST

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch on.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine and ECT / Active Test.

    5. Perform the Active Test.

      Tester Display
      Test Details
      Control Range
      Diagnostic Notes
      Test the Fuel Leak
      Pressurizes common rail internal fuel pressure, and checks for fuel leaks
      Stop/Start
      1. Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2,000 rpm when ON is selected
      2. Above conditions preserved while test is ON

← PARTS LOCATION (from Oct 2014)COMPONENTS (from Oct 2014) →