2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


CHECK FOR FUEL LEAKS
  1. Check that there are no fuel leaks anywhere on the fuel system after doing maintenance.

    HINT:
    When checking for fuel leaks, make sure that there is pressure in the fuel line.


CHECK INJECTION OR SUPPLY PUMP ASSEMBLY

  1. Inspect the engine speed sensor.

    1. B012956
      Using an ohmmeter, measure the resistance between the terminals.

      Resistance:
      205 to 255 Ω at 20°C (69°F)

  1. Inspect the spill control valve.

    1. B012767
      Using an ohmmeter, measure the resistance between the terminals.

      Resistance:
      1 to 2 Ω at 20°C (69°F)

  1. Inspect the timing control valve.

    1. B012766E01
      Using an ohmmeter, measure the resistance between the terminals.

      Resistance:
      10 to 14 Ω at 20°C (69°F)

  1. Inspect the timing control valve solenoid operation.

    1. Connect the battery positive terminal to the timing control valve terminal +B.

    2. Connect the battery negative terminal to the timing control valve terminal TCV.

    3. Check that the solenoid makes a 'click' sound.

      NOTICE:
      1. Do not apply voltage for more than 30 seconds to avoid burning out the timing control valve solenoid.
      2. If repeating this step, wait until the solenoid coils become cool enough that the solenoid can be touched by hand.

← PARTS LOCATION (from Oct 2014)INSPECTION (from Oct 2014) →