2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Oct 2014


1. REMOVE FRONT SEAT ASSEMBLY RH (for Hi-back Seat Type)

HINT:
Use the same procedures described for the LH side. (Click here)


2. REMOVE FRONT SEAT ASSEMBLY RH (for Low-back Seat Type)

HINT:
Use the same procedures described for the LH side. (Click here)


3. REMOVE FRONT DOOR SCUFF PLATE RH

4. REMOVE ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY
  1. Turn back the carpet, and remove the engine service hole cover sub-assembly.


5. SEPARATE AIR CLEANER HOSE NO.2
  1. Loosen the bolt, and disconnect the air cleaner hose No.2.


6. REMOVE INTAKE AIR CONNECTOR SUB-ASSEMBLY
  1. Disconnect the ventilation hose.

  1. Disconnect the turbo pressure sensor connector.

  1. A111051
    Remove the bolt, 3 nuts, intake air connector and gasket.


7. REMOVE INTAKE AIR CONNECTOR BRACKET

  1. A112061
    Remove the 2 bolts and intake air connector bracket.


8. REMOVE VENTURI ASSEMBLY

  1. A111052E01
    Disconnect the throttle open switch connector.

  1. A111053E01
    Disconnect the throttle control motor connector.

  1. Remove the venturi and gasket.


9. REMOVE INJECTION PIPE SET
  1. Loosen the 8 union nuts of the 4 injection pipes.

  1. Remove the 2 nuts, 2 upper pipe clamps, and 4 injection pipes with lower pipe clamps.


10. REMOVE GLOW PLUG NO.1 CONNECTOR
  1. Remove the vehicle's side wire harness, glow plug screw grommets and nuts, and disconnect the glow plug No.1 connector.


11. REMOVE NOZZLE LEAKAGE PIPE ASSEMBLY
  1. Disconnect the fuel hose from the leakage pipe.

  1. Remove the 4 nuts, leakage pipe and the 4 ring packing washers.


12. REMOVE NOZZLE HOLDER AND NOZZLE SET
  1. Using SST, remove the 4 injection nozzles, 4 injection nozzle seats and 4 injection nozzle seat gaskets.

    SST
    09268-64010   (09268-64020)

← COMPONENTS (from Oct 2014)INSPECTION (from Oct 2014) →