2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2015

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


1. INSTALL CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

  1. A337845
    for Intake Side:

    1. Apply a light coat of engine oil to the a new O-ring, and install it to the camshaft timing oil control valve assembly.

      NOTICE:
      Do not damage the O-ring when installing.

      HINT:
      An O-ring is already installed in a new camshaft timing oil control valve assembly. So, the O-ring only needs to be coated with engine oil when the assembly is replaced with a new one.

    2. Install the camshaft timing oil control valve assembly to the cylinder head sub-assembly with the bolt.

      Torque:
      9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

      NOTICE:
      1. Replace with a new part if it is dropped or if it receives a strong impact.
      2. Make sure that the O-ring is not cracked or jammed when installing.

    3. Connect the camshaft timing oil control valve connector.

  1. for Exhaust Side:

    1. Apply a light coat of engine oil to the a new O-ring, and install it to the camshaft timing oil control valve assembly.

      NOTICE:
      Do not damage the O-ring when installing.

      HINT:
      An O-ring is already installed in a new camshaft timing oil control valve assembly. So, the O-ring only needs to be coated with engine oil when the assembly is replaced with a new one.

    2. Install the camshaft timing oil control valve assembly to the cylinder head cover sub-assembly with the bolt.

      Torque:
      9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

      NOTICE:
      1. Replace with a new part if it is dropped or if it receives a strong impact.
      2. Make sure that the O-ring is not cracked or jammed when installing.

    3. Connect the camshaft timing oil control valve connector.


2. CONNECT VANE PUMP ASSEMBLY
  1. Connect the vane pump assembly with the 2 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

  1. Connect the oil pressure switch connector.


3. INSTALL INTAKE AIR CONNECTOR
(Click here)

4. INSTALL FAN AND GENERATOR V BELT
(Click here)
← INSTALLATION (Oct 2014 – Dec 2014)COMPONENTS (Oct 2014 – Dec 2014) →