INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT IGNITION SWITCH |
Measure the resistance according to the value(s) in the table below.

- Standard Resistance:
Tester Connection
Switch Condition
Specified Condition
Between all terminals
LOCK
10 kΩ or higher
2 (AM1) - 3 (ACC)
ACC
Below 1 Ω
2 (AM1) - 3 (ACC)
2 (AM1) - 4 (IG1)
5 (IG2) - 6 (AM2)
ON
Below 1 Ω
1(ST1) - 2 (AM1)
1 (ST1) - 4 (IG1)
5 (IG2) - 6 (AM2)
5 (IG2) - 7 (ST2)
START
Below 1 Ω
If the result is not as specified, replace the ignition switch.Text in Illustration *a
Component without harness connected
(Ignition Switch)
*b
LOCK
*c
ACC
*d
ON
*e
START
