INSTALLATION
Removal / installation · Vehicles built from Jan 2017
Versions by build date: Oct 2014 – Dec 2016 from Jan 2017
| 1.
INSTALL ENGINE REAR OIL SEAL |
 |
- Apply MP grease to a new oil seal lip.
- NOTICE:
- Keep the lip free from foreign matter.
Using SST, tap in the oil seal until its surface is flush with the engine rear oil seal retainer edge.
- SST
- 09223-15030
09950-70010
(09951-07100)
- NOTICE:
- Wipe off extra grease on the crankshaft.
| 2.
INSTALL FLYWHEEL HOUSING DUST SEAL |
 |
Install the flywheel housing dust seal.
| 3.
INSTALL REAR END PLATE |
 |
Install the 2 bolts and rear end plate.
-
Torque:
- 27 N*m{
275 kgf*cm
, 19 ft.*lbf
}
| 4.
INSTALL FLYWHEEL SUB-ASSEMBLY |
 |
- Using SST, hold the crankshaft.
- SST
- 09213-54015
(91651-60855)
09330-00021
Clean the bolts and bolt holes.
Apply adhesive to 2 or 3 threads of the bolts.
- Adhesive:
- Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent
Install the flywheel on the crankshaft.
- Install and uniformly tighten the 8 bolts in several steps, in the sequence shown.
-
Torque:
- 123 N*m{
1,250 kgf*cm
, 90 ft.*lbf
}
- NOTICE:
- Do not start the engine within an hour after installing.
| 5.
INSTALL CLUTCH DISC ASSEMBLY
|
 |
- Insert SST into the clutch disc assembly, then insert them into the flywheel sub-assembly.
- SST
- 09301-00110
- NOTICE:
- Take care not to insert the clutch disc assembly in the wrong direction.
| 6.
INSTALL CLUTCH COVER ASSEMBLY
|
 |
- Align the matchmarks on the clutch cover assembly with the one on the flywheel sub-assembly.
Following the procedures shown in the illustration, tighten the 6 bolts starting from the bolt located near the knock pin on the top.
- SST
- 09301-00110
-
Torque:
- 19 N*m{
195 kgf*cm
, 14 ft.*lbf
}
- HINT:
- Evenly tighten the bolts by following the order shown in the illustration.
- Tighten the bolts after checking that the disc is in the center by lightly moving the SST up and down, left and right.
| 7.
INSTALL MANUAL TRANSMISSION ASSEMBLY |
 |
(Click here)