Radio Receiver Power Source Circuit
Circuit diagnosis · Vehicles built from Jan 2017
Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
DESCRIPTION
This circuit provides power to the radio receiver assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
- NOTICE:
- Inspect the fuses for circuits related to this system before performing the following inspection procedure.
| 1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER ASSEMBLY- BATTERY AND BODY GROUND) |
Disconnect the radio receiver assembly connector.

Measure the resistance according to the value(s) in the table below.
- Standard Resistance:
Tester Connection
Condition
Specified Condition
I2-7 (GND) - Body ground
Always
Below 1 Ω
Measure the voltage according to the value(s) in the table below.
- Standard Voltage:
Tester Connection
Condition
Specified Condition
I2-4 (B) - Body ground
Always
11 to 14 V
I2-3 (ACC) - Body ground
Ignition switch ACC
| *a |
Front view of wire harness connector (to Radio Receiver Assembly) |
|
|
||||
| OK | ||
| ||
