2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT ACCELERATOR PEDAL ROD ASSEMBLY
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / Accel Sens. No.1 Volt % and Accel Sens. No.2 Volt %.

  1. Operate the accelerator pedal rod and check that the "Accel Sens. No.1 Volt %" and "Accel Sens. No.2 Volt %" values are within the specification.

    Standard Voltage (Accel Sens. No.1 Volt %):
    Accelerator Pedal Condition
    Specified Condition
    Released
    10 to 22%
    Depressed
    52 to 90%

    Standard Voltage (Accel Sens. No.2 Volt %):
    Accelerator Pedal Condition
    Specified Condition
    Released
    24 to 40%
    Depressed
    68 to 95%

    If the result is not as specified, check the accelerator pedal rod assembly, wire harness or ECM.

← COMPONENTS (from Oct 2014)REMOVAL (from Oct 2014) →