2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT DIESEL TURBO PRESSURE SENSOR

  1. Check the terminal voltage.

    1. Disconnect the diesel turbo pressure sensor connector.

    2. Turn the ignition switch to ON.

    3. A241069E10
      Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Condition
      Specified Condition
      D57-3 (VC) - D57-1 (E)
      Ignition switch ON
      4.75 to 5.25 V
      D57-2 (PIM) - D57-1 (E)
      Ignition switch ON
      3.0 to 5.0 V

      Text in Illustration 
      *a
      Front view of wire harness connector
      (to Diesel Turbo Pressure Sensor)
      If the result is not as specified, there is an open or short in VC or E circuit.

  1. Check the intake manifold pressure.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / MAP.

    5. Read the values displayed on the GTS.

      OK:
      Equivalent to atmospheric pressure.

      HINT:
      1. Standard atmospheric pressure is 101 kPa (abs) [758 mmHg (abs)].
      2. For every 100 m (328 ft.) increase in altitude, pressure drops by 1 kPa (7.5 mmHg). This varies by weather.

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →