2014-2019 Hiace · Service Manual ENGINE

BASIC INSPECTION

Troubleshooting · Vehicles built from Oct 2014

HINT:
When a malfunction cannot be confirmed by the DTC check, troubleshooting should be performed on all circuits that are possible causes of the problem. However, in most cases, performing the basic engine check shown below can help you find the problem quickly and efficiently. Always perform this check first when troubleshooting the engine.


1.CHECK BATTERY VOLTAGE

    NOTICE:
    Perform the battery voltage check with the engine stopped and the ignition switch off.

    Result 
    Result
    Proceed to
    11 V or higher
    OK
    Below 11 V
    NG

NG.
OK

2.CHECK IF ENGINE WILL CRANK

    NG.
    OK

    3.CHECK AIR FILTER
    1. Visually check that the air filter is not excessively contaminated with dirt or oil.


    NG.
    OK

    4.CHECK FUEL QUALITY
    1. Check that only diesel fuel is being used.

    2. Check that the fuel does not contain any impurities.


    NG.
    OK

    5.CHECK FUEL FOR AIR

      NG.
      OK

      6.CHECK FUEL PIPES AND HOSES
      1. Check that the fuel pipes and fuel hoses are not blocked, damaged, disconnected or bent.


      NG.
      OK

      7.CHECK FUEL FILTER ELEMENT SUB-ASSEMBLY FOR BLOCKAGE

        NG.
        OK

        8.CHECK ENGINE OIL

          NG.
          OK

          9.CHECK ENGINE COOLANT

            NG.
            OK

            10.CHECK IDLING SPEED AND MAXIMUM SPEED

              NG.
              OK

              11.CHECK DIAGNOSTIC CIRCUIT

                NG.
                OK

                12.CHECK VACUUM PUMP

                  NG.
                  OK

                  ← CHECK FOR INTERMITTENT PROBLEMS (from Jan 2017)REGISTRATION (Oct 2014 – Dec 2014) →