2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2015

Versions by build date: Oct 2014 – Dec 2014 from Jan 2015


1. INSTALL CAMSHAFT POSITION SENSOR (w/o Dual VVT-i)
  1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

  1. Install the camshaft position sensor with the bolt.

    Torque:
    9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

    NOTICE:
    1. When reusing the camshaft position sensor, inspect the O-ring.
    2. Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.

  1. Connect the camshaft position sensor connector.


2. INSTALL CAMSHAFT POSITION SENSOR (w/ Dual VVT-i)
  1. for Intake Side:

    1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

    2. Install the camshaft position sensor with the bolt.

      Torque:
      9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

      NOTICE:
      1. When reusing the camshaft position sensor, inspect the O-ring.
      2. Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.

    3. Connect the camshaft position sensor connector.

  1. for Exhaust Side:

    1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

    2. Install the camshaft position sensor with the bolt.

      Torque:
      9.0 N*m{ 92 kgf*cm , 80 in.*lbf }

      NOTICE:
      1. When reusing the camshaft position sensor, inspect the O-ring.
      2. Make sure that the O-ring is not cracked or jammed when installing the camshaft position sensor.

    3. Connect the camshaft position sensor connector.


3. INSTALL INTAKE AIR CONNECTOR (w/ Dual VVT-i)
  1. Temporarily install the intake air connector to the throttle body assembly.

  1. Connect the vacuum hose to the intake air connector.

  1. A239458E01
    Connect the No. 2 PCV hose to the cylinder head cover sub-assembly, and slide the clamp to secure the hose.

  1. Install the intake air connector with the 2 bolts.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Tighten the 2 hose clamps.

    Torque:
    for clamp A:
    5.0 N*m{ 51 kgf*cm , 44 in.*lbf }


4. INSTALL ENGINE SERVICE HOLE SUB COVER SUB-ASSEMBLY (w/ Dual VVT-i)
  1. Install the engine service hole sub cover with the 5 bolts.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }


5. INSTALL FRONT DOOR SCUFF PLATE RH (w/ Dual VVT-i)

6. INSTALL FRONT SEAT ASSEMBLY RH (w/ Dual VVT-i)
(Click here)
← INSTALLATION (Oct 2014 – Dec 2014)COMPONENTS (from Oct 2014) →