2014-2019 Hiace · Service Manual TRANSMISSION

HOW TO PROCEED WITH TROUBLESHOOTING

Troubleshooting · Vehicles built from Oct 2014


When using intelligent tester, troubleshoot in accordance with the procedure on the following pages.

HINT:
  1. The TCM of this system is connected to the CAN system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN system.
  2. The intelligent tester can be used at steps 3, 4, 6, and 9.


1.Vehicle Brought to Workshop
    NEXT

    2.Customer Problem Analysis
      NEXT

      3.Connect the intelligent tester to DLC3
        NEXT

        4.Check and Clear DTC and Freeze Frame Data
          NEXT

          5.Visual Inspection
            NEXT

            6.Setting the Check Mode Diagnosis
              NEXT

              7.Problem Symptom Confirmation

                .

                .
                8.Symptom Simulation
                  NEXT

                  9.DTC Check

                    .

                    .
                    10.Basic Inspection

                      NG.
                      OK

                      11.Mechanical System Test

                        NG.
                        OK

                        12.Hydraulic Test

                          NG.
                          OK

                          13.Manual Shifting Test

                            NG.
                            OK

                            14.Problem Symptoms Table Chapter 1

                              NG.
                              OK

                              15.Problem Symptoms Table Chapter 2

                                NG.
                                OK

                                16.Problem Symptoms Table Chapter 3
                                  NEXT

                                  17.Part Inspection

                                    .
                                    18.DTC Chart
                                      NEXT

                                      19.Circuit Inspection
                                        NEXT

                                        20.Repair or Replace
                                          NEXT

                                          21.Confirmation Test
                                            NEXT


                                            When not using intelligent tester, troubleshoot in accordance with the procedure on the following pages.

                                            HINT:
                                            The TCM of this system is connected to the CAN system. Therefore, before starting troubleshooting, make sure to check that there is no trouble in the CAN system.


                                            1.Vehicle Brought to Workshop
                                              NEXT

                                              2.Customer Problem Analysis
                                                NEXT

                                                3.Check and Clear DTCs
                                                  NEXT

                                                  4.Problem Symptom Confirmation

                                                    .

                                                    .
                                                    5.Symptom Simulation
                                                      NEXT

                                                      6.DTC Check

                                                        .

                                                        .
                                                        7.Basic Inspection

                                                          NG.
                                                          OK

                                                          8.Mechanical System Test

                                                            NG.
                                                            OK

                                                            9.Hydraulic Test

                                                              NG.
                                                              OK

                                                              10.Manual Shifting

                                                                NG.
                                                                OK

                                                                11.Problem Symptoms Table Chapter 1

                                                                  NG.
                                                                  OK

                                                                  12.Problem Symptoms Table Chapter 2

                                                                    NG.
                                                                    OK

                                                                    13.Problem Symptoms Table Chapter 3
                                                                      NEXT

                                                                      14.Part Inspection

                                                                        .
                                                                        15.DTC Chart
                                                                          NEXT

                                                                          16.Circuit Inspection
                                                                            NEXT

                                                                            17.Repair or Replace
                                                                              NEXT

                                                                              18.Confirmation Test
                                                                                NEXT

                                                                                ← SYSTEM DESCRIPTION (from Oct 2014)ROAD TEST (Oct 2014 – Dec 2014) →