2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT NO. 1 INTEGRATION RELAY (C/OPN)

A225101E16
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    10A-1 - 10A-4
    Battery voltage not applied to terminals 10A-2 and 10A-3
    10 kΩ or higher
    Battery voltage applied to terminals 10A-2 and 10A-3
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (No. 1 Integration Relay)
    If the result is not as specified, replace the No. 1 integration relay.


INSPECT NO. 1 INTEGRATION RELAY (EFI)
  1. Check the EFI NO. 1 fuse.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      EFI NO. 1 fuse
      Always
      Below 1 Ω

      If the result is not as specified, replace the EFI NO. 1 fuse.

  1. A225101E16
    Check the EFI relay.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      10C-1 - 10A-8
      Battery voltage not applied to terminals 10A-6 and 10A-7
      10 kΩ or higher
      Battery voltage applied to terminals 10A-6 and 10A-7
      Below 1 Ω

      Text in Illustration 
      *a
      Component without harness connected
      (No. 1 Integration Relay)
      If the result is not as specified, replace the No. 1 integration relay.


INSPECT NO. 1 INTEGRATION RELAY (INJ)

  1. A225101E16
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    10B-1 - 10B-4
    Battery voltage not applied to terminals 10B-2 and 10B-3
    10 kΩ or higher
    Battery voltage applied to terminals 10B-2 and 10B-3
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (No. 1 Integration Relay)
    If the result is not as specified, replace the No. 1 integration relay.


INSPECT NO. 1 INTEGRATION RELAY (A/F)

  1. A225101E16
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    10B-5 - 10B-8
    Battery voltage not applied to terminals 10B-6 and 10B-7
    10 kΩ or higher
    Battery voltage applied to terminals 10B-6 and 10B-7
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (No. 1 Integration Relay)
    If the result is not as specified, replace the No. 1 integration relay.

← REMOVAL (from Oct 2014)INSTALLATION (Oct 2014 – Dec 2016) →