ON-VEHICLE INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT THROTTLE BODY ASSEMBLY |
Check the throttle control motor operating sounds.
Turn the ignition switch to the ON position.
When pressing the accelerator pedal, listen to the running sounds of the motor. Make sure no friction noise comes from the motor.

If friction noise exists, replace the throttle body.
Check the throttle position sensor.

Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the intelligent tester main switch on.
Enter the following menus: Power train / Engine / Data List / Throttle Sensor Position and Throttle Position Sensor Position #2.
Depress the accelerator pedal. When the throttle valve is fully opened, check that the value of the "Throttle Sensor Position" is within the specification.
- Standard throttle valve opening percentage:
- 60% or more
- NOTICE:
- When checking the standard throttle valve opening percentage, the shift lever should be in the N position.
- HINT:
- If the percentage is less than 60%, replace the throttle body.
