2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT MASS AIR FLOW METER

  1. Check the output voltage.

    1. G037688E08
      Apply battery voltage across terminals 1 (+B) and 2 (E2G).
      Text in Illustration 
      *a
      Air

      NOTICE:
      While using the battery during inspection, do not bring the positive and negative tester probes too close to each other as a short circuit may occur.

    2. Using a voltmeter, connect the positive (+) tester probe to terminal 3 (VG) and the negative (-) tester probe to terminal 2 (E2G).

    3. Blow air into the mass air flow meter and check that the voltage fluctuates.
      If the voltage does not fluctuate, replace the mass air flow meter.

  1. Check the resistance.

    1. G037689E06
      Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      4 (THA) - 5 (E2)
      -20°C (-4°F)
      12.5 to 16.9 kΩ
      4 (THA) - 5 (E2)
      20°C (68°F)
      2.19 to 2.67 kΩ
      4 (THA) - 5 (E2)
      60°C (140°F)
      0.50 to 0.68 kΩ

      Text in Illustration 
      *a
      Component without harness connected
      (Mass Air Flow Meter)
      *b
      Resistance
      *c
      Temperature
      *d
      Acceptable Range
      If the result is not as specified, replace the mass air flow meter.

← REMOVAL (from Oct 2014)INSTALLATION (from Oct 2014) →