2014-2019 Hiace · Service Manual ENGINE

REMOVAL

Removal / installation · Vehicles built from Jan 2017


1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
(Click here)

2. REMOVE FLYWHEEL SUB-ASSEMBLY

  1. A343925
    Remove the 4 bolts and crankshaft pulley cover from the crankshaft pulley.

  1. A349457E01
    Using SST, hold the crankshaft pulley.
    SST
    09213-58014   (91551-80840)
    09330-00021  

  1. A344484
    Remove the 8 bolts, rear drive plate spacer, pump impeller drive plate and flywheel sub-assembly from the crankshaft.


3. REMOVE REAR END PLATE

  1. A396827
    Remove the bolt and rear end plate from the cylinder block sub-assembly.


4. REMOVE NO. 5 CYLINDER BLOCK INSULATOR

  1. A343523
    Remove the No. 5 cylinder block insulator from the cylinder block sub-assembly.


5. REMOVE NO. 1 CYLINDER BLOCK INSULATOR

  1. A343524
    Remove the No. 1 cylinder block insulator from the cylinder block sub-assembly.


6. REMOVE CONNECTING WIRE

A346045
  1. Disconnect the 2 connectors and clamp, and remove the connecting wire.


7. REMOVE CRANKSHAFT POSITION SENSOR HARNESS BRACKET

A346046
  1. Remove the bolt and crankshaft position sensor harness bracket from the cylinder block sub-assembly.


8. REMOVE CRANKSHAFT POSITION SENSOR

A346047
  1. Remove the bolt and crankshaft position sensor from the rear oil seal retainer.

← COMPONENTS (from Jan 2017)INSTALLATION (from Jan 2017) →