2014-2019 Hiace · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jan 2017


1. INSTALL CAMSHAFT POSITION SENSOR
  1. Apply a light coat of engine oil to the O-ring of the camshaft position sensor.

  1. Install the camshaft position sensor with the bolt to the cylinder head cover sub-assembly.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }

    NOTICE:
    1. When reusing the camshaft position sensor, check the O-rings.
    2. Make sure that the O-ring is not cracked or jammed when installing it on the cylinder head cover sub-assembly.
    3. Replace with a new part if it is dropped or if it receives a strong impact.

  1. Connect the camshaft position sensor connector.

← REMOVAL (from Jan 2017)COMPONENTS (from Jan 2017) →