INSPECTION
Inspection · Vehicles built from Oct 2014
| INSPECT RADIATOR CAP SUB-ASSEMBLY |
- NOTICE:
- If the reservoir cap is contaminated, always rinse it with water.
- Before using a radiator cap tester, wet the relief valve and pressure valve with engine coolant or water.
- When performing steps (a) and (b) below, keep the tester at an angle of over 30°C above the horizontal.
- If the reservoir cap is contaminated, always rinse it with water.
Using a radiator cap tester, slowly pump the tester and check that air is coming from the vacuum valve.
- Pump speed:
- 1 push every 3 seconds or more
- NOTICE:
- Push the pump at a constant speed.
- HINT:
- If air is not coming from the vacuum valve, replace the radiator cap.
Pump the tester and measure the relief valve opening pressure.
- Pump speed:
- 1 push within 1 second
- NOTICE:
- The pump speed above should be followed for the first pump only. After the vacuum valve is closed, the pump speed can be reduced.
- Standard opening pressure:
- 93.3 to 122.7 kPa (0.95 to 1.25 kgf*cm2, 13.5 to 17.8 psi)
- Minimum opening pressure:
- 78.5 kPa (0.8 kgf*cm2, 11.1 psi)
- HINT:
- Pay attention to the tester's maximum reading of the opening pressure. If the maximum reading is less than the minimum opening pressure above, replace the radiator cap.
