2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT RADIATOR RESERVOIR CAP SUB-ASSEMBLY

  1. Measure the valve opening pressure.

    1. A215769E01
      If there are water stains or foreign matter on the O-ring, clean it with water and finger scouring.
      Text in Illustration 
      *1
      O-ring
      *2
      Rubber Packing

      NOTICE:
      Do not use any tools.

    2. Check that the O-ring is not deformed, cracked or damaged.

    3. Check that the O-ring is not swollen.

    4. If there are water stains or foreign matter on the O-ring, clean it with water and finger scouring.

    5. Check that the O-ring is not deformed, cracked or swollen.

    6. Apply engine coolant to the O-ring and rubber packing before using the radiator cap tester.

    7. B008802E16
      When using the cap tester, tilt it 30° or more.
      Text in Illustration 
      *1
      Radiator Reservoir Cap Sub-assembly
      *a
      Radiator Cap Tester
      *b
      30° or more

    8. Pump the cap tester several times, and check the maximum pressure*1.

      Pumping speed:
      1 pump per second

      HINT:
      *1: Even if the cap cannot maintain the maximum pressure, it is not necessarily defective.

      Judgment Criterion:
      Item
      Specified Condition
      Standard value (for brand-new cap)
      94 to 122 kPa (1.0 to 1.2 kgf/cm2, 13.6 to 17.7 psi)
      Minimum standard value (for used cap)
      79 kPa (0.8 kgf/cm2, 11.4 psi)

      If the maximum pressure is less than the minimum standard value, replace the radiator reservoir cap sub-assembly.

← ON-VEHICLE INSPECTION (from Oct 2014)PARTS LOCATION (from Oct 2014) →