INSTALLATION
Removal / installation · Vehicles built from Oct 2014
| 1. INSTALL OIL FILTER SUB-ASSEMBLY |
Check and clean the oil filter installation surface.
Apply clean engine oil to the rubber gasket of a new oil filter.
Instal the oil filter, and tighten it by hand until the rubber gasket contacts the installation surface.
Using SST, tighten it by an additional 3/4 turn to seat the filter.

- SST
- 09228-44011
| 2. ADD ENGINE OIL |
Fill with fresh engine oil.
- Oil capacity:
Oil capacity
Drain and refill - w/ oil filter change
- w/o oil filter change
6.9 liters (7.3 US qts, 6.1 Imp. qts)
6.1 liters (6.4 US qts, 5.4 Imp. qts)
Dry fill
7.6 liters (8.0 US qts, 6.7 Imp. qts)
- w/ oil filter change
Reinstall the oil filler cap.
| 3. INSPECT CHECK FOR ENGINE OIL LEAKS |
