2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built Oct 2014 – Nov 2017

Versions by build date: Oct 2014 – Nov 2017 from Dec 2017


CHECK ENGINE OIL LEVEL
  1. Warm up the engine and then wait for 5 minutes after turning the engine off. The oil level should be between the low level and full level marks of the dipstick.

    1. If low, check for leakage and add oil up to the full level mark.

      NOTICE:
      Do not fill with engine oil above the full level mark.


CHECK ENGINE OIL QUALITY

  1. A113489E03
    Check the oil for deterioration, traces of water, discoloring, or thinning.

  1. If the quality is visibly poor, replace the oil.

    Oil grade:
    API grade CF - 4 or CF (You may also use API CE or CD) SAE 5W - 30 is the best choice for your vehicle, for good fuel economy, and good starting in cold weather.


REMOVE OIL PRESSURE SWITCH ASSEMBLY
  1. Disconnect the oil pressure switch connector.

  1. Using a 24 mm deep socket wrench, remove the oil pressure switch.


INSTALL OIL PRESSURE GAUGE

  1. A058649E01
    Install the oil pressure gauge.


WARM UP ENGINE

CHECK OIL PRESSURE

Oil pressure:
Engine rpm
Oil pressure
At idle
29 kPa (0.3 kgf*cm2, 4.3 psi) or more
At 3,000 rpm
294 to 539 kPa (3.0 to 5.5 kgf*cm2, 43 to 78 psi)


INSTALL OIL PRESSURE SWITCH
  1. Remove the oil pressure gauge.

  1. A113490E01
    Apply adhesive to 2 or 3 threads of the oil pressure switch.

    Adhesive:
    Toyota Genuine Adhesive 1344, Three Bond 1344 or equivalent

  1. Using a 24 mm deep socket wrench, install the oil pressure switch.

    Torque:
    15 N*m{ 152 kgf*cm , 11 ft.*lbf }

    NOTICE:
    Do not start the engine 1 hour after the installation.

  1. Connect the oil pressure switch connector.


START ENGINE AND CHECK FOR LEAKS
← INSTALLATION (from Apr 2016)ON-VEHICLE INSPECTION (from Dec 2017) →