2014-2019 Hiace · Service Manual ENGINE

REPLACEMENT

Removal / installation · Vehicles built from Oct 2014


1. REPLACE TIMING GEAR CASE OIL SEAL

HINT:
There are 2 methods to remove the oil seal.

  1. If the timing gear cover is removed from the cylinder block:

    1. A058117E01
      Using a screwdriver and hammer, tap out the oil seal.

    2. A058118E02
      Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.
      SST
      09223-15020  
      09502-12010  
      09950-70010   (09951-07100)

    3. Apply MP grease to the lip of the oil seal.

  1. If the timing gear cover is installed to the cylinder block:

    1. A058126E02
      Using a knife, cut through the lip of the oil seal.

    2. Using a screwdriver, pry out the oil seal.

      NOTICE:
      Be careful not to damage the crankshaft.

    3. A058127E01
      Apply MP grease to the lip of the oil seal.

    4. Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.

      SST
      09223-15020  
      09502-12010  
      09950-70010   (09951-07100)


2. REPLACE TIMING GEAR COVER OIL SEAL

HINT:
There are 2 methods to remove the oil seal.

  1. If the timing gear cover is removed from the cylinder block:

    1. A058121E01
      Using a screwdriver and hammer, tap out the oil seal.

    2. A058119E01
      Using SST and a hammer, tap in a new oil seal until its surface is flush with the timing gear cover edge.
      SST
      09214-76011  

    3. Apply MP grease to the lip of the oil seal.

  1. If the timing gear cover is installed to the cylinder block:

    1. A058124E01
      Using SST, remove the oil seal.
      SST
      09308-10010  
      09950-40011   (09957-04010)
      09950-60010   (09951-00350)

    2. A058125E01
      Apply MP grease to the lip of a new oil seal.

    3. Using SST and a hammer, tap in the oil seal until its surface is flush with the timing gear cover edge.

      SST
      09214-76011  


3. REPLACE REAR ENGINE OIL SEAL

  1. A061819E01
    Using a screwdriver and hammer, tap out the oil seal.

  1. A253830E01
    Using SST and a hammer, tap in a new oil seal until its surface is flush with the rear oil seal retainer edge.
    SST
    09518-36030  
    09950-70010   (09951-07100)

  1. Apply MP grease to the lip of the oil seal.


4. REPLACE CONNECTING ROD SMALL END BUSH

  1. A060209E02
    Using SST and a press, press out the bush.
    SST
    09222-76012  

  1. A060210E02
    Align the oil holes of a new bush and the connecting rod.

  1. A060209E02
    Using SST and a press, press in the bush.
    SST
    09222-76012  

  1. A054733E01
    Using a pin hole grinder, hone the bush to obtain the standard specified clearance between the bush and piston pin.

  1. A060207E02
    Check the piston pin fit at normal room temperature.

    1. Coat the piston pin with engine oil, and push it into the connecting rod with your thumb.

← INSPECTION (from Oct 2014)REASSEMBLY (from Oct 2014) →