2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014

NOTICE:
Turn the ignition switch off for 60 seconds before performing the following inspections.


INSPECT ILLUMINATION DURATION OF GLOW INDICATOR LIGHT

  1. A247216E01
    Turn the ignition switch to ON and measure the length of time that the light remains illuminated.

    Light illumination duration:
    Refer to the graph.

    Text in Illustration 
    *a
    Glow Indicator Light Illumination Time
    *b
    Engine Coolant Temperature
    *c
    Atmospheric pressure is 100 kPa

    HINT:
    Depending on the engine coolant temperature, the indicator light illumination time changes as shown in the illustration.


INSPECT PRE-HEATING FUNCTION
  1. Measure the voltage applied to the glow plugs.

    Standard voltage:
    11 to 14 V at 25°C (77°F) or less

  1. Measure the length of time that voltage is applied to the glow plugs while the ignition switch is ON.

    Standard Pre-heating Time:
    Condition
    Pre-heating Time
    Battery voltage 14.5 V or higher
    1 second
    Engine coolant temperature 40°C (104°F) or higher
    1 second
    Other than above
    15 seconds


INSPECT AFTERGLOW
  1. Measure the voltage applied to the glow plugs after the engine is started.

    Standard Voltage:
    Measurement Condition
    Specified Condition
    Engine coolant temperature 40°C (77°F) or less
    11 to 14 V
    Engine coolant temperature 40°C (77°F) or higher
    0 V

    HINT:
    The maximum amount of time that voltage is applied to the glow plugs is 20 minutes.

← SYSTEM DIAGRAM (from Oct 2014)PARTS LOCATION (from Oct 2014) →