2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT LIGHTING TIME OF GLOW INDICATOR LIGHT

NOTICE:
Turn the ignition switch off for 60 seconds before performing this inspection.

  1. A112489E02
    Turn the ignition switch to the ON position, and measure the lighting time.

    Lighting time:
    Refer to the chart graph


INSPECT PRE-HEATING

NOTICE:
Turn the ignition switch off for 60 seconds before performing this inspection.

  1. A112490E01
    Turn the ignition switch to the ON position, measure the time when the battery voltage is applied to the glow plugs.

    Pre-Heating time :
    Engine coolant temperature
    Pre-Heating time
    40°C or more
    1 sec.
    40°C or less
    Refer to the chart graph (15 sec. at the longest)

  1. Turn the ignition switch to the START position, and check the battery voltage is applied to the glow plugs.

  1. While cranking the engine, measure the time when the battery voltage is applied to the glow plugs.

    Pre-Heating time:
    Engine coolant temperature
    Pre-Heating time
    40°C or more
    1 sec.
    40°C or less
    Refer to the chart graph (15 sec. at the longest)


INSPECT AFTER GLOW TIME

NOTICE:
Turn the ignition switch off for 60 seconds before performing this inspection.

  1. Remove the glow relay.

  1. A112491E01
    After the engine starts, measure the length of time that battery voltage remains present.

    Standard After Glow Time:
    Tester Connection
    Specified Condition
    2 - Body ground
    Refer to the graph above*1

    *1: After glow time changes depending on atmospheric pressure and engine coolant temperature.
    If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plug and glow relay.


INSPECT GLOW PLUGS

NOTICE:
Turn the ignition switch off for 60 seconds before performing this inspection.

  1. A112492E01
    Using an ohmmeter, measure the resistance between the glow plug terminal and ground.

    Standard resistance:
    Approx. 0.72Ωat 20°C (68°F)

    NOTICE:
    1. Do not damage the glow plug pipes as it could cause an open circuit or shorten life of the glow plugs.
    2. Avoid getting oil and gasoline on the glow plug when cleaning.
    3. During inspection, be sure to wipe any oil on the terminal and bakelite washer with a dry cloth.
    4. Do not apply more than 11 V to the glow plug as it could cause an open circuit.

← SYSTEM DIAGRAM (from Oct 2014)COMPONENTS (from Oct 2014) →