2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2017

NOTICE:
Turn the ignition switch off for 60 seconds before performing the following inspections.


INSPECT ILLUMINATION DURATION OF GLOW INDICATOR LIGHT

  1. A301596E01
    Turn the ignition switch to ON and measure the length of time that the light remains illuminated.

    Light illumination duration:
    Refer to the graph

    Text in Illustration 
    *a
    Glow Indicator Light Illumination Time
    *b
    Engine Coolant Temperature
    *c
    When atmospheric pressure is 100 kPa (1.0 kgf/cm2)

    HINT:
    Depending on the engine coolant temperature, the indicator light illumination time changes as shown in the illustration.


INSPECT PRE-HEATING FUNCTION
  1. Measure the voltage applied to the glow plug assemblies.

    Standard voltage:
    11 to 14 V at 25°C (77°F) or less

  1. Measure the length of time that voltage is applied to the glow plug assemblies while the ignition switch is ON.

    Standard Pre-heating Time:
    Condition
    Pre-heating Time
    Battery voltage at 14 V or higher
    1 second
    Engine coolant temperature 40°C (104°F) or higher
    1 second
    Other than above
    15 seconds


INSPECT AFTER GLOW
  1. Measure the voltage applied to the glow plug assemblies after the engine is started.

    Standard Voltage:
    Measurement Condition
    Specified Condition
    Engine coolant temperature 20°C (68°F) or less
    11 to 14 V
    Engine coolant temperature 20°C (68°F) to 41°C (106°F)
    0 to 14 V
    Engine coolant temperature 41°C (106°F) or higher
    0 V

    HINT:
    The maximum amount of time that voltage is applied to the glow plug assemblies is 20 minutes.

← SYSTEM DIAGRAM (from Jan 2017)COMPONENTS (from Jan 2017) →