DISASSEMBLY
Removal / installation · Vehicles built from Oct 2014
| 1. REMOVE REAR END COVER |
Remove the nut and terminal insulator.

Remove the bolt, 3 nuts, plate terminal, and rear end cover.
| 2. REMOVE BRUSH HOLDER AND REGULATOR |
Remove the brush holder cover.
Remove the 2 screws and brush holder.

Remove the seal plate.
Remove the 3 screws and regulator.
| 3. REMOVE GENERATOR HOLDER W/ RECTIFIER |
Remove the 4 screws and generator holder w/ rectifier.

Remove the 4 rubber insulators.
| 4. REMOVE RECTIFIER END FRAME |
Remove the 4 nuts and cord clamp.

Using SST, remove the rectifier end frame.

- SST
- 09286-46011
Remove the washer from the rotor.
| 5. REMOVE GENERATOR ROTOR ASSEMBLY |
Using SST and press, press out the rotor.

- SST
- 09950-60010
(09951-00180)
09950-70010 (09951-07100)
