Removal / installation · Vehicles built from Oct 2014
1.
INSTALL SUN GEAR INPUT DRUM SHAFT SNAP RING
Using a screwdriver, install the snap ring on the planetary sun gear.
2.
INSTALL SUN GEAR INPUT DRUM
Place a wooden block or similar object as a work stand and place the planetary sun gear onto it.
Install the sun gear input drum onto the planetary sun gear.
Using a snap ring expander, install the snap ring.
3.
INSTALL SUN GEAR SHAFT OIL SEAL RING
Coat the 2 oil seal rings with ATF.
Install the 2 oil seal rings onto the planetary sun gear.
NOTICE:
Do not over-spread the ring ends.
HINT:
After installing the oil seal rings, check that they rotate smoothly.
4.
INSTALL ONE WAY CLUTCH THRUST WASHER NO.1
HINT:
Make sure that the lug shapes fit into the holes in the sun gear input drum.
5.
INSTALL ONE WAY CLUTCH ASSEMBLY
Install the 1 way clutch assembly.
6.
INSPECT ONE WAY CLUTCH ASSEMBLY
Hold the planetary sun gear, and turn the 1 way clutch assembly Check that the 1 way clutch assembly hub can be freely clockwise and locked counterclockwise.