2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Jan 2017


INSPECT DIESEL TURBO PRESSURE SENSOR

  1. Inspect the power source voltage.

    1. Disconnect the diesel turbo pressure sensor connector.

    2. Turn the ignition switch to ON.

    3. A200310E32
      Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Condition
      Specified Condition
      3 (VC) - 1 (E2)
      Ignition switch ON
      4.75 to 5.25 V

      Text in Illustration 
      *a
      Front view of wire harness connector
      (to Diesel Turbo Pressure Sensor)

    4. Turn the ignition switch off.

    5. Connect the diesel turbo pressure sensor connector.

    6. Clear the DTCs.

  1. Inspect the diesel turbo pressure sensor.

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Enter the following menus: Powertrain / Engine and ECT / Data List / Atmosphere Pressure and MAP.

    5. Disconnect the vacuum hose from the diesel turbo pressure sensor.

    6. A398608E01
      Using SST, apply pressure to the diesel turbo pressure sensor.
      SST
      09992-00242  
      Text in Illustration 
      *a
      Vacuum Pump

    7. Using a vacuum pump, apply vacuum to the diesel turbo pressure sensor.

    8. Read the value.

      OK:
      Condition
      MAP Value
      No pressure applied
      Same as atmospheric pressure
      Pressure applied
      Indicates pressure
      Vacuum applied
      Indicates vacuum

      If the result is not as specified, replace the diesel turbo pressure sensor or ECM.

← COMPONENTS (from Jan 2017)REMOVAL (from Jan 2017) →