2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT STARTER ASSEMBLY

NOTICE:
The following tests must be done within 3 to 5 seconds to avoid the coil from out.

  1. B000457E01
    Perform pull-in test.

    1. Disconnect the field coil lead wire from terminal C.

    2. Connect the battery to the magnetic switch as shown. Check that the clutch pinion gear moves outward.

  1. B000458E01
    Perform holding test.

    1. When the battery is connected as above with the clutch pinion gear out, disconnect the negative (-) lead from terminal C. Check that the pinion gear remains out.

  1. B000459E01
    Inspect clutch pinion gear return.

    1. Disconnect the negative (-) lead from the starter body. Check that the clutch pinion gear returns inward.

  1. B000460E01
    Perform the operation test without load.

    1. Connect the field coil lead wire to terminal C.

      Torque:
      5.9 N*m{ 60 kgf*cm , 52 in.*lbf }

    2. Grip the starter with a vise.

    3. Connect the battery and ammeter to the starter as shown.

    4. Check that the ammeter reads the specified current.

      Specified current:
      120 A or less at 11.5 V


INSPECT STARTER RELAY ASSEMBLY

  1. E109078E01
    Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      3 - 5
      10 kΩ or higher
      3 - 5
      Below 1 Ω (when battery voltage is applied to terminals 1 and 2)

      If the result is not as specified, replace the relay.

← SYSTEM DIAGRAM (from Oct 2014)PARTS LOCATION (from Oct 2014) →