2014-2019 Hiace · Service Manual BRAKE

INSTALLATION

Removal / installation · Vehicles built from Jan 2017


1. INSTALL VACUUM PUMP UNION

  1. C331081
    Install the 2 new gaskets and the vacuum pump union with the union bolt.

    Torque:
    14 N*m{ 140 kgf*cm , 10 ft.*lbf }

    HINT:
    Check that the stopper of the vacuum pump union with union is securely held on the vacuum pump assembly.


2. INSTALL CAMSHAFT OIL SEAL RETAINER
Click here

3. INSTALL VACUUM PUMP ASSEMBLY

  1. When using new vacuum pump assembly:

    1. C331082
      Apply engine oil to the No. 2 and No. 3 O-rings installed in a new vacuum pump assembly.
      Text in Illustration 
      V100135
      Engine oil

  1. When reusing vacuum pump assembly:

    1. Install a new No. 2 and No. 3 O-rings to the vacuum pump assembly.

    2. C331082
      Apply engine oil to the No. 2 and No. 3 O-rings installed in the vacuum pump assembly.
      Text in Illustration 
      V100135
      Engine oil

  1. A343514
    Install the vacuum pump assembly so that the oil pipe engages with the hole of the camshaft and the coupling teeth with the grooves on the camshaft tip.

    NOTICE:
    1. Ensure that the vacuum pump assembly is installed securely.
    2. Be careful not to pinch the O-ring.

  1. Install the vacuum pump assembly with the 3 bolts.

    Torque:
    21 N*m{ 214 kgf*cm , 15 ft.*lbf }

    NOTICE:
    After installation, check that there are no gaps between the matching surfaces and that the vacuum pump assembly is not installed at an angle.


4. CONNECT NO. 1 VACUUM TRANSMITTING HOSE
  1. Connect the No. 1 vacuum transmitting hose to the vacuum pump assembly.


5. REMOVE ENGINE ASSEMBLY TO ENGINE STAND
Click here

6. INSTALL ENGINE ASSEMBLY
(Click here)

7. INSPECT VACUUM PUMP OPERATION
  1. Disconnect the vacuum hose from the vacuum pump.

  1. C374023E01
    Connect the hose of the vacuum gauge to the vacuum pump.
    Text in Illustration 
    *a
    Vacuum Gauge

  1. Start the engine and warm it up for more than 2 minutes.

  1. With the engine idling, check the negative pressure of the vacuum pump.

    Standard pressure:
    Higher than 87 kPa (650 mmHg, 25.6 in.Hg)

    HINT:
    1. It is necessary to replace the vacuum pump every 200000 km (124000 miles).
    2. If the result is not as specified, replace the vacuum pump.

  1. Remove the vacuum gauge from the vacuum pump.

  1. Connect the vacuum hose to the vacuum pump.

← REASSEMBLY (from Jan 2017)COMPONENTS (from Oct 2014) →