2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT STARTER ASSEMBLY

CAUTION:
As a large electric current passes through the cable during this inspection, a thick cable must be used. If not, the cable may become hot and cause injury.

NOTICE:
The following tests must each be performed within 3 to 5 seconds to prevent the coil from burning out.

  1. Mount the starter assembly in a vise between aluminum plates.

    NOTICE:
    Ensure that the starter assembly is secured in the vise to prevent it from falling out.

  1. Perform pull-in test.

    1. A313839
      Remove the nut and disconnect the lead wire from terminal C.

    2. A099965E04
      Connect the battery to the magnet starter switch assembly as shown in the illustration. Then check that the clutch pinion gear moves outward.
      Text in Illustration 
      *a
      Terminal 50
      *b
      Terminal C
      V100135
      Moves Outward
      If the clutch pinion gear does not move out ward, replace the magnet starter switch assembly.

  1. Perform holding test.

    1. A313838E01
      Disconnect the negative (-) terminal lead from terminal C with the condition specified in the pull-in test above being maintained. Check that the clutch pinion gear remains out.
      Text in Illustration 
      *a
      Terminal C
      V100135
      Disconnect
      If the pinion gear moves inward, replace the magnet starter switch assembly.

  1. Check the return operation.

    1. A251379
      Disconnect the negative (-) terminal lead from the starter body. Check that the clutch pinion gear returns inward.
      Text in Illustration 
      V100135
      Disconnect
      V100136
      Returns Inward
      If the clutch pinion gear does not move inward, replace the magnet starter switch assembly.

  1. Perform operation test no-load.

    1. Connect the lead wire to terminal C with the nut.

      Torque:
      9.8 N*m{ 100 kgf*cm , 87 in.*lbf }

    2. A267494E03
      Connect the battery and an ammeter to the starter assembly as shown in the illustration.
      Text in Illustration 
      *a
      Terminal 30
      *b
      Terminal 50

      NOTICE:
      Do not allow any lead to get caught as the clutch pinion gear operates.

    3. Check that the starter assembly rotates smoothly and steadily while the clutch pinion gear is moving outward. Then measure the current.

      Standard current:
      90 A or less at 11.5 V

      If the result is not as specified, repair or replace the starter assembly.

← SYSTEM DIAGRAM (from Oct 2014)COMPONENTS (Oct 2014 – Dec 2014) →