2014-2019 Hiace · Service Manual HEATER & AIR CONDITIONING SYSTEM

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT HEATER BLOWER SWITCH ASSEMBLY (REAR BLOWER SWITCH)

  1. E289361E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    4 (B) - 1 (D)
    OFF
    10 kΩ or higher
    4 (B) - 1 (D)
    ON
    Below 1 Ω

    If the result is not as specified, replace the heater blower switch assembly (rear blower switch).
    Text in Illustration 
    *a
    Component without harness connected
    (Heater Blower Switch Assembly)

  1. Check the heater indicator operation.

    1. Connect the positive (+) lead from the battery to terminal 4 (B) and the negative (-) lead to terminal 5 (E).

    2. Push the heater blower switch assembly, and check that the indicator light comes on.

      OK:
      The indicator light comes on.

      If the resistance is not as specified, replace the heater blower switch assembly (rear blower switch).

  1. Check the illumination operation.

    1. Connect the positive (+) lead from the battery to terminal 3 (ILL+) and the negative (-) lead to terminal 2 (ILL-), and check that the illumination light comes on.

      OK:
      The illumination light comes on.

      If the resistance is not as specified, replace the heater blower switch assembly (rear blower switch).

← REMOVAL (from Jan 2017)INSTALLATION (Oct 2014 – Mar 2016) →