2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT GLOW PLUG
  1. Remove the No. 1 glow plug connector (Click here).

  1. Check the resistance.

    1. A241511
      Using an ohmmeter, measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Condition
      Specified Condition
      Glow plug terminal - Body ground
      20°C (68°F)
      Approximately 1.2 Ω

      NOTICE:
      Measure the resistance of the glow plug with it installed to the cylinder head.

      If the result is not as specified, replace the glow plug.

  1. Install the No. 1 glow plug connector (Click here).

← COMPONENTS (from Oct 2014)REMOVAL (from Oct 2014) →