2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT ILLUMINATION DURATION OF GLOW INDICATOR LIGHT

  1. Inspect the light illumination duration.

    1. Turn the ignition switch to ON, and then measure the light illumination duration.

      Light illumination duration:
      Refer to the graph.


      A264694E01
      Text in Illustration 
      *a
      Light Illumination Duration
      *b
      Engine Coolant Temperature

    2. Turn the ignition switch off.

      HINT:
      Actual light illumination duration may vary slightly from the graph.

      If the result is not as specified, inspect the ECM, engine coolant temperature sensor, glow plug and glow relay.


INSPECT PRE-HEATING

  1. Inspect the pre-heating time.

    A152816E02

    Text in Illustration 
    *a
    Pre-heating Time
    *b
    Battery Voltage

    1. Turn the ignition switch to ON. Measure how long it takes for battery voltage to be applied to the glow plugs.

      Standard Time:
      Engine Coolant Temperature
      Specified Condition
      40°C (104°F) or higher
      1 second
      Below 40°C (104°F)
      Refer to the graph
      (maximum: 21 seconds)

      If the result is not as specified, inspect the ECM, engine coolant temperature sensor, glow plug and glow relay.

    2. Turn the ignition switch off.

  1. Turn the ignition switch to START. Check that battery voltage is applied to the glow plugs.

  1. While cranking the engine, measure how long it takes for battery voltage to be applied to the glow plugs.

    Standard Time:
    Engine Coolant Temperature
    Specified Condition
    40°C (104°F) or higher
    1 second
    Below 40°C (104°F)
    Refer to the graph
    (maximum: 21 seconds)

    If the result is not as specified, inspect the ECM, engine coolant temperature sensor, glow plug and glow relay.


INSPECT AFTER GLOW TIME
  1. Remove the glow relay.

  1. A321765E01
    After the engine starts, measure the length of time that battery voltage remains present.

    Standard After Glow Time:
    Tester Connection
    Specified Condition
    2 - Body ground
    Refer to the graph above*1

    Text in Illustration 
    *1
    After Glow Time (Sec.)
    *2
    Engine Coolant Temperature °C (°F)
    *1: After glow time changes depending on atmospheric pressure and engine coolant temperature.
    If the result is not as specified, check the ECM, engine coolant temperature sensor, glow plug and glow relay.

  1. Install the glow relay.

← SYSTEM DIAGRAM (from Oct 2014)PRECAUTION (from Oct 2014) →