2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014

NOTICE:
Turn the ignition switch off for 60 seconds before performing the following inspections:


INSPECT LIGHTING TIME OF GLOW INDICATOR LIGHT

  1. A114042E01
    Turn the ignition switch to the ON position, and measure the lighting time.

    Lighting time:
    Refer to the graph.


INSPECT PRE-HEATING

  1. A114043E01
    Turn the ignition switch to the ON position, measure the time when the battery voltage is applied to the glow plugs.

    Pre-Heating time:
    Engine coolant temperature
    Pre-Heating time
    40°C or more
    1 sec.
    Less than 40°C
    Refer to the graph (15 sec. at the longest)

  1. Turn the ignition switch to the START position, and check that the battery voltage is applied to the glow plugs.

  1. While cranking the engine, measure the time when the battery voltage is applied to the glow plugs.

    Pre-Heating time:
    Engine coolant temperature
    Pre-Heating time
    40°C or more
    1 sec.
    Less than 40°C
    Refer to the chart graph (15 sec. at the longest)


INSPECT AFTER GLOW TIME
  1. Remove the glow relay.

  1. A321772E01
    After the engine starts, measure the length of time that battery voltage remains present.

    Standard After Glow Time:
    Tester Connection
    Specified Condition
    2 - Body ground
    Refer to the graph above*1

    *1: After glow time changes depending on atmospheric pressure and engine coolant temperature.

  1. Install the glow relay.

← SYSTEM DIAGRAM (from Oct 2014)COMPONENTS (from Oct 2014) →