2014-2019 Hiace · Service Manual BODY ELECTRICAL

INSPECTION

Inspection · Vehicles built from Oct 2014

HINT:
Use the same procedure for RHD and LHD vehicles.


INSPECT HEADLIGHT LEVELING SWITCH

E289583E01
  1. Check the voltage.

    1. Connect the positive (+) lead from the battery to terminal 5 (B) and the negative (-) lead to terminal 1 (E).

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage:
      Tester Connection
      Switch Position
      Specified Condition
      (Battery voltage is 12 V)
      5 (B) - 2 (T)
      0
      9.48 to 10.2 V
      1
      8.06 to 8.78 V
      2
      6.77 to 7.37 V
      3
      5.23 to 5.95 V
      4
      3.82 to 4.54 V
      5
      2.40 to 3.12 V

      If the result is not as specified, replace the headlight leveling switch.
      Text in Illustration 
      *a
      Component without harness connected
      (Headlight Leveling Switch)

  1. E289583E02
    Illumination Inspection.

    1. Apply battery voltage to the connector and check the illumination condition.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Terminal 3 (ILL+)
      Battery negative (-) → Terminal 4 (ILL-)
      Illuminates

      If the result is not as specified, replace the headlight leveling switch.
      Text in Illustration 
      *a
      Component without harness connected
      (Headlight Leveling Switch)

← ON-VEHICLE INSPECTION (from Oct 2014)INSPECTION (from Oct 2014) →