2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT COOLING FAN RELAY

  1. A035654E01
    Check the resistance.

    1. Using an ohmmeter, measure the resistance between the terminals.

      Standard resistance:
      Tester Connection
      Specified Condition
      3 - 5
      10 kΩ or higher
      3 - 5
      Below 1 Ω (when battery voltage is applied between terminals 1 and 2)

      If the result is not as specified, replace the relay.


INSPECT COOLING FAN MOTOR
  1. Check that the motor turns smoothly when the battery is connected to the fan motor connector.

  1. Using an ammeter, measure the current while the motor is turning.

    Standard:
    17 to 23 A (20°C (68°F)) at 12 V


ENGINE COOLANT TEMPERATURE SENSOR

  1. Partially soak the sensor in the water and warm up the water.

    A108624E01

  1. Measure the resistance between the terminals.

    Standard resistance:
    Condition
    Specified Condition
    Approx. 20°C (68°F)
    2.32 to 2.59 kΩ
    Approx. 80°C (176°F)
    0.310 to 0.326 kΩ

    If the result is not as specified, replace the sensor.

    NOTICE:
    When checking the sensor in the water, keep the terminals dry. After the check, wipe the sensor dry.

← ON-VEHICLE INSPECTION (from Oct 2014)REPLACEMENT (Oct 2014 – Dec 2014) →