2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT COOLING FAN RELAY (FAN 1)

  1. A169584E07
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    Battery voltage is applied between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the cooling fan relay.


INSPECT NO. 2 COOLING FAN RELAY (FAN 2)

  1. A169584E07
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Battery voltage is not applied between terminals 1 and 2
    10 kΩ or higher
    Battery voltage is applied between terminals 1 and 2
    Below 1 Ω

    If the result is not as specified, replace the No. 2 cooling fan relay.


INSPECT NO. 1 COOLING FAN MOTOR

  1. A267514E01
    Check that the motor turns smoothly when the battery is connected to the fan motor connector.
    Text in Illustration 
    *a
    Component without harness connected
    (No. 1 Cooling Fan Motor)

  1. Measure the current according to the value(s) in the table below.

    Standard Current:
    Item
    Condition
    Specified Condition
    No. 1 cooling fan motor
    20°C (68°F)
    17 to 23 A

    If the result is not as specified, replace the No. 1 cooling fan motor.


INSPECT NO. 2 COOLING FAN MOTOR

  1. A267514E01
    Check that the motor turns smoothly when the battery is connected to the fan motor connector.
    Text in Illustration 
    *a
    Component without harness connected
    (No. 2 Cooling Fan Motor)

  1. Measure the current according to the value(s) in the table below.

    Standard Current:
    Item
    Condition
    Specified Condition
    No. 2 cooling fan motor
    20°C (68°F)
    17 to 23 A

    If the result is not as specified, replace the No. 2 cooling fan motor.


INSPECT ENGINE COOLANT TEMPERATURE SENSOR (RADIATOR)

  1. A224398E02
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    1 - 2
    20 °C (68 °F)
    2.32 to 2.59 kΩ
    1 - 2
    80 °C (176 °F)
    0.310 to 0.326 kΩ

    Text in Illustration 
    *a
    Component without harness connected
    (Engine Coolant Temperature Sensor)
    *b
    Resistance
    *c
    Temperature
    *d
    Acceptable Range

    NOTICE:
    If checking the engine coolant temperature sensor in water, be careful not to allow water to intrude into the terminals. After checking, clean off water on the engine coolant temperature sensor.

    If the result is not as specified, replace the engine coolant temperature sensor.

← ON-VEHICLE INSPECTION (from Oct 2014)REPLACEMENT (Oct 2014 – Dec 2014) →