DISASSEMBLY
Removal / installation · Vehicles built from Oct 2014
| 1.
INSPECT 1 WAY CLUTCH ASSEMBLY
|
 |
- Hold the planetary sun gear, and turn the 2nd brake hub. Check that the 2nd brake hub can be turned freely clockwise and locked counterclockwise.
| 2.
REMOVE 1 WAY CLUTCH ASSEMBLY |
 |
- Remove the 1 way clutch assembly.
| 3.
REMOVE 1 WAY CLUTCH THRUST WASHER NO.1 |
 |
- Remove the 1 way clutch thrust washer No.1.
| 4.
REMOVE SUN GEAR SHAFT OIL SEAL RING |
 |
- Remove the sun gear shaft oil seal rings.
| 5.
REMOVE SUN GEAR INPUT DRUM |
 |
- Use a wooden block or similar object as a work stand.
- Using a snap ring expander, remove the snap ring.
Remove the sun gear input drum from the planetary sun gear.
| 6.
REMOVE SUN GEAR INPUT DRUM SHAFT SNAP RING |
 |
- Using a screwdriver, remove the snap ring from the planetary sun gear.
| 7.
INSPECT PLANETARY SUN GEAR SUB-ASSEMBLY
|
 |
- Using a dial indicator, measure the inside diameter of the planetary sun gear bushings.
- Maximum inside diameter:
- 27.08 mm (1.0661 in.)
If the inside diameter is greater than the maximum, replace the planetary sun gear.