2014-2019 Hiace · Service Manual ENGINE

P2226 Barometric Pressure Circuit

Diagnostic trouble codes · Vehicles built from Jan 2017

Also covers:

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017

DESCRIPTION

To detect atmospheric pressure, the built-in atmospheric pressure sensor in the ECM is used. Using the atmospheric pressure, the ECM corrects the injection volume, timing and duration, and adjusts the common rail internal fuel pressure in order to optimize engine combustion.
P2226 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Ignition switch to ON for 1 second
Atmospheric pressure sensor voltage is 1.4 V or less, or 4.0 V or higher for 0.5 seconds (1 trip detection logic).
ECM
P2228 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Ignition switch to ON for 1 second
Atmospheric pressure sensor voltage is 1.4 V or less for 0.5 seconds (1 trip detection logic).
ECM
P2229 
DTC Detection Drive Pattern
DTC Detection Condition
Trouble Area
Ignition switch to ON for 1 second
Atmospheric pressure sensor voltage is 4.0 V or higher for 0.5 seconds (1 trip detection logic).
ECM
Related Data List 
DTC No.
Data List
P2226
  1. Atmosphere Pressure
  2. MAP
P2228
P2229

HINT:
  1. When the ignition switch to ON, the intake manifold pressure, "MAP", is approximately equal to atmospheric pressure.
  2. Under standard atmospheric pressure conditions, the output of the atmospheric pressure sensor is 101 kPa. For every 100 m increase in elevation, pressure drops by 1 kPa. This varies by weather (high atmospheric pressure, low atmospheric pressure).
  3. If DTC P2226, P2228 and/or P2229 is stored, the following symptoms may appear:
    1. Misfire
    2. Combustion noise
    3. Black smoke
    4. White smoke


INSPECTION PROCEDURE

NOTICE:
After replacing the ECM, the new ECM needs registration (Click here) and initialization (Click here).

HINT:
Read freeze frame data using the GTS. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, and other data from the time the malfunction occurred.


1. REPLACE ECM
  1. Replace the ECM (Click here).


NEXT


2. CONFIRM WHETHER MALFUNCTION HAS BEEN SUCCESSFULLY REPAIRED
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Clear the DTCs (Click here).

  1. Turn the ignition switch to ON and wait for 1 second or more.

  1. Confirm that the DTC is not output again.


NEXT

END


← P2226 Barometric Pressure Circuit (+ P2228, P2229) (Apr 2016 – Dec 2016)U0101 Lost Communication with TCM (Oct 2014 – Dec 2014) →