2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL INPUT SHAFT FRONT BEARING

  1. D029020E01
    Using SST and a press, install a new input shaft front bearing onto the input shaft.
    SST
    09950-60010   (09951-00570)
    09950-70010   (09951-07100)

    NOTICE:
    Install the input shaft front bearing with the snap ring groove facing to the front.


2. INSTALL FRONT BEARING SHAFT SNAP RING

  1. D026115
    Select a front bearing snap ring so that the clearance between the input shaft and input shaft front bearing is within the specified values.

    Standard clearance:
    0.1 mm (0.0039 in.) or less
    Mark
    Thickness
    A
    2.10 to 2.15 mm (0.0827 to 0.0846 in.)
    B
    2.15 to 2.20 mm (0.0846 to 0.0866 in.)
    C
    2.20 to 2.25 mm (0.0866 to 0.0886 in.)
    D
    2.25 to 2.30 mm (0.0886 to 0.0906 in.)
    E
    2.30 to 2.35 mm (0.0906 to 0.0925 in.)
    F
    2.35 to 2.40 mm (0.0925 to 0.0945 in.)
    G
    2.40 to 2.45 mm (0.0945 to 0.0965 in.)


3. INSTALL INPUT SHAFT BEARING

  1. D026114
    Apply gear oil to the input shaft bearing and install it onto the input shaft.


4. INSTALL SYNCHRONIZER RING NO.2

  1. D026113
    Apply gear oil to the synchronizer ring No.2, and install it onto the input shaft.

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →