2014-2019 Hiace · Service Manual TRANSMISSION

REASSEMBLY

Removal / installation · Vehicles built from Oct 2014


1. INSTALL COUNTER GEAR FRONT BEARING

  1. D026124E01
    Using SST and a press, install the counter gear front bearing onto the counter gear.
    Install it so that the snap ring groove of the bearing faces to the front side.


2. INSTALL COUNTER GEAR FRONT BEARING SNAP RING NO.2

  1. D026119
    Select the correct counter gear front bearing snap ring No.2 so that the clearance between the counter gear and counter gear front bearing snap ring No.2 is within the specified values. Using a brass bar and a hammer, install it onto the counter gear.

    Standard clearance:
    0.1 mm (0.0039 in.) or less

    Mark
    Thickness mm (in.)
    A
    2.05 to 2.10 mm (0.0807 to 0.0827 in.)
    B
    2.10 to 2.15 mm (0.0827 to 0.0846 in.)
    C
    2.15 to 2.20 mm (0.0846 to 0.0866 in.)
    D
    2.20 to 2.25 mm (0.0866 to 0.0886 in.)
    E
    2.25 to 2.30 mm (0.0886 to 0.0906 in.)
    F
    2.30 to 2.35 mm (0.0906 to 0.0925 in.)

← INSPECTION (from Oct 2014)COMPONENTS (from Oct 2014) →