2014-2019 Hiace · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2014


CHECK DIFFERENTIAL PRESSURE SENSOR ASSEMBLY
  1. Connect the GTS to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the GTS on.

  1. Enter the following menus: Powertrain / Engine and ECT / Data List / DPF Differential Pressure.

  1. Slide the clip and disconnect the No. 6 exhaust pipe air hose from the differential pressure sensor assembly.

  1. A240556E02
    Using SST, apply pressure to the differential pressure sensor assembly.
    SST
    09992-00242  
    Text in Illustration 
    *a
    Pressure
    *b
    Rear Side of Vehicle

  1. Check the pressure value of the differential pressure sensor assembly.

    Standard pressure:
    Approximately the same pressure as the applied pressure indicated on the GTS.

    HINT:
    Perform the inspection by applying a pressure within the range of 0 to 98 kPa (0 to 1.0 kgf/cm2, 0 to 14.2 psi).

    If the result is not as specified, check the sensor circuit (Click here).

  1. Connect the No. 6 exhaust pipe air hose to the differential pressure sensor assembly, slide the clip to secure the hose.

← COMPONENTS (from Oct 2014)REMOVAL (from Oct 2014) →