2014-2019 Hiace · Service Manual BODY ELECTRICAL

U0100 Lost Communication with ECM / PCM "A"

Diagnostic trouble codes · Vehicles built Jan 2015 – Dec 2016

Also covers:

Versions by build date: Oct 2014 – Dec 2014 Jan 2015 – Dec 2016 from Jan 2017

DESCRIPTION

  1. *1: w/ ABS
  2. *2: w/ Airbag System
  3. *3: for LED Headlight
The combination meter assembly communicates with the ECM via the CAN communication system.
The combination meter assembly communicates with the brake actuator assembly (skid control ECU) via the CAN communication system*1.
The combination meter assembly communicates with the center airbag sensor assembly via the CAN communication system*2.
The combination meter assembly communicates with the headlight leveling ECU assembly via the CAN communication system*3.
DTC Code
DTC Detection Condition
Trouble Area
U0100
Both conditions are met:
  1. IG voltage is 10.5 V or higher.
  2. No communication with the ECM continues for 2 seconds or more.
  1. ECM
  2. CAN communication system
  3. Combination meter assembly
U0129*1
Both conditions are met:
  1. IG voltage is 10.5 V or higher.
  2. No communication with the brake actuator assembly (skid control ECU) continues for 10 seconds or more.
  1. Brake actuator assembly (skid control ECU)
  2. CAN communication system
  3. Combination meter assembly
U0151*2
Both conditions are met:
  1. IG voltage is 10.5 V or higher.
  2. No communication with the center airbag sensor assembly continues for 10 seconds or more.
  1. Center airbag sensor assembly
  2. CAN communication system
  3. Combination meter assembly
U0182*3
Both conditions are met:
  1. IG voltage is 10.5 V or higher.
  2. No communication with the headlight leveling ECU assembly continues for 10 seconds or more.
  1. Headlight leveling ECU assembly
  2. CAN communication system
  3. Combination meter assembly

INSPECTION PROCEDURE


1. CHECK FOR DTC
  1. Check for DTCs (Click here).

    HINT:
    If CAN communication system DTC U0100, U0129*1, U0151*2 or U0182*3 and another DTC are output at the same time, perform troubleshooting for CAN communication system DTC U0100, U0129*1, U0151*2 or U0182*3 first.

    OK:
    NO DTCs are output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)


← U0100 Lost Communication with ECM / PCM "A" (+ U0182) (Oct 2014 – Dec 2014)U0100 Lost Communication with ECM / PCM "A" (+ U0129, U0151, U0182) (from Jan 2017) →