2014-2019 Hiace · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built from Oct 2014


INSPECT ENGINE SWITCH

  1. A295732E01
    Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    5 (SS1) - 6 (AGND)
    Not pushed
    10 kΩ or higher
    1 (SS2) - 6 (AGND)
    5 (SS1) - 6 (AGND)
    Pushed
    Below 1 Ω
    1 (SS2) - 6 (AGND)

    Text in Illustration 
    *a
    Component without harness connected
    (Engine Switch)
    If the result is not as specified, replace the engine switch.

  1. Apply battery voltage between the terminals of the engine switch and check the illumination of the engine switch.

    OK:
    Measurement Condition
    Specified Condition
    Battery positive (+) → Terminal 9 (SWIL)
    Battery negative (-) → Terminal 6 (AGND)
    Illuminates (illumination of lettering)

    NOTICE:
    1. If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.
    2. If the voltage is too low, the indicator will not illuminate.

    If the result is not as specified, replace the engine switch.

← REMOVAL (from Jan 2017)INSTALLATION (Oct 2014 – Mar 2016) →