P0630 VIN not Programmed or Mismatch - ECM / PCM
Diagnostic trouble codes · Vehicles built Apr 2016 – Dec 2016
Versions by build date: Jan 2015 – Nov 2015 Dec 2015 – Mar 2016 Apr 2016 – Dec 2016 from Jan 2017
DESCRIPTION
DTC P0630 is stored when the Vehicle Identification Number (VIN) is not stored in the ECM, or the input VIN is incorrect. The VIN is input with the GTS.| DTC No. |
DTC Detection Condition |
Trouble Area |
| P0630 |
Either condition is met (1 trip detection logic):
|
ECM |
MONITOR STRATEGY
| Required sensors/Components |
ECM |
| Frequency of operation |
Continuous |
TYPICAL MALFUNCTION THRESHOLDS
| VIN code |
Not programmed |
CONFIRMATION DRIVING PATTERN
- Connect the GTS to the DLC3.
- Turn the ignition switch to ON and turn the GTS on.
- Clear the DTCs (even if no DTCs are stored, perform the clear DTC operation).
- Turn the ignition switch off and wait for at least 30 seconds.
- Turn the ignition switch to ON and turn the GTS on [A].
- Wait 5 seconds or more.
- Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
- Read the pending DTCs.
- HINT:
- If a pending DTC is output, the system is malfunctioning.
- If a pending DTC is not output, perform the following procedure.
- If a pending DTC is output, the system is malfunctioning.
- Enter the following menus: Powertrain / Engine and ECT / Utility / All Readiness.
- Input the DTC: P0630.
- Check the DTC judgment result.
GTS Display
Description
NORMAL
- DTC judgment completed
- System normal
ABNORMAL
- DTC judgment completed
- System abnormal
INCOMPLETE
- DTC judgment not completed
- Perform driving pattern after confirming DTC enabling conditions
N/A
- Unable to perform DTC judgment
- Number of DTCs which do not fulfill DTC preconditions has reached ECU memory limit
- HINT:
- If the judgment result shows NORMAL, the system is normal.
- If the judgment result shows ABNORMAL, the system has a malfunction.
- If the judgment result shows NORMAL, the system is normal.
- DTC judgment completed
INSPECTION PROCEDURE
| 1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0630) |
Connect the GTS to the DLC3.
Turn the ignition switch to ON and turn the GTS on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
- Result:
Result
Proceed to
P0630
A
P0630 and other DTCs
B
- NOTICE:
- If P0630 is stored, the VIN must be input to the ECM using the GTS. However, DTCs are cleared automatically by the GTS when the VIN is input. If DTCs other than P0630 are output, troubleshoot those DTCs first.
|
|
||||
| A | |
| 2. INPUT VIN |
Refer to the Registration (Click here).
| NEXT | ||
| ||
