Removal / installation · Vehicles built from Oct 2014
1.
REPLACE TRANSMITTER BATTERY
NOTICE:
Take extra care when handling these precision electronic components.
Slide the release hook knob and pull the emergency key in the order indicated in the illustration.
Insert a precision screwdriver into the gap, and turn the screwdriver to detach the transmitter housing cover.
NOTICE:
Do not use excessive force when prying apart the transmitter housing cover.
HINT:
Tape the screwdriver tip before use.
Text in Illustration
*1
Protective Tape
Remove the transmitter battery housing cover.
Insert a precision screwdriver into the gap and gently remove the transmitter battery (lithium battery: CR2032).
NOTICE:
Do not push the terminals with your finger.
Do not forcibly pry up the transmitter battery. The terminals may be damaged.
Do not touch the transmitter battery with wet hands. Water may cause rust.
Do not touch or move any components inside the transmitter. Doing so may interfere with proper operation.
When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical transmitter from being damaged.
HINT:
Tape the screwdriver tip before use.
Text in Illustration
*1
Protective Tape
Install a new transmitter battery (lithium battery: CR2032) with the positive (+) side facing upward as shown in the illustration.
NOTICE:
Do not bend the transmitter battery electrode during insertion.
Keep the transmitter housing case interior free of dust and oil.
When replacing the transmitter battery, before starting work, remove static electricity that has built up in the body by touching, for example, the vehicle to prevent the electrical key transmitter sub-assembly from being damaged.
Install the transmitter battery housing cover.
HINT:
Press down on the entire circumference of the transmitter battery housing cover.
Install the transmitter housing cover.
Insert the emergency key into the electrical key transmitter sub-assembly.
Press one of the transmitter switches and check that the LED illuminates.